Publication No. GEG-99054 Genicom Mar 00
9-10 microLaser 210 User Guide
Testingthe Offset Catch Tray
8. Close the rear coverof the printer.
Testingthe Of fset CatchTray
After installing the offset catch tray, use the following test procedure to verify that it is operating
correctly.
1. Turnthe printer on by pressing the [ I ] on the power switch on the front left of the printer.
2. Once the printer has warmed up and displays the “Ready” message on the control panel dis-
play,use any software applic ation to print a few sheets to the offset catch tray.
3. If thefeederdoesnotfeedpaperorifthecontrolpaneldisplaysanerrormessage,refer
to“Solving Offset Catch Tray Problems”on page 9-10.
Solving Offset Catch Tray Problems
When there is a problem with the offset catch tray, the printer control panel displays an error code
and error message. Mostoffset catch tray error codes indicate routine status conditions such as a
paper jam. Some errorcodes indicate much more serious problems that may requirethe help of a
service technician.
■If the offset catch tray is inoperative after installation, refer to “Installation Problems” on
page 9-11 and complete the recommended procedure.
■If the printer control panel displays an error message or an error code, refer to “Interpreting
Offset Catch TrayError Messages” on page 9-11.
■If you have an offset catch tray problem but the printer control panel does not display an
error message or error code, refer to “Correcting Miscellaneous OffsetCatch Tray Prob-
lems” on page 9-13 and follow the directions for correc ting that problem.