Grizzly G0740 owner manual Inventory, Box 1 Figure Qty Steady Rest Assembly Installed

Inventory

The following is a list of items shipped with your machine. Before beginning setup, lay these items out and inventory them.

If any non-proprietary parts are missing (e.g. a nut or a washer), we will gladly replace them; or for the sake of expediency, replacements can be obtained at your local hardware store.

Box 1: (Figure 11)		Qty
A. Steady Rest Assembly (Installed)		1
B.	10" Faceplate w/D1-5 Camlock Stud Set....	1
C.	10" 4-Jaw Chuck w/Reversible Jaws	1

A B

D C

F

E

Figure 11. Main inventory.

D.	3-Jaw Chuck Key	1
E.	4-Jaw Chuck Key	1
F.	Follow Rest Assembly (Installed)	1

Tool Box Inventory: (Figure 12)		Qty
G.	Tool Box	1
H.	Open End Wrench 22/24mm	1
I.	Open End Wrench 14/17mm	1
J.	Open End Wrench 10/12mm	1
K.	Phillips Screwdriver #2	1
L.	Standard Screwdriver #2	1
M.	Hex Wrench 8mm	1
N.	Tapered Spindle Sleeve MT#5-#3	1

G

Q

R

S

H

N

O

T

U

J

P

I

K

L

M

V

O.	Dead Center MT#3	1
P.	Carbide-Tipped Dead Center MT#3	1
Q.	Camlock Key D1-5	1
R.	Tool Post T-Wrench (Clamped on Tool
	Post)	1
S.	Hex Wrench Set 1.5-10mm	1
T.	Carriage Handwheel Handle	1
U.	Cross Slide Handwheel Handle	1
V.	Cast Iron Leveling Pads	6

Pre-Installed (Not Shown)		Qty
•	8" 3-Jaw Chuck w/2-Pc. Jaw Set	................ 1
•	8⁜1⁄4" Back Plate D1-5	1

Model G0740 (Mfg. Since 11/12)

Figure 12. Toolbox inventory.

NOTICE

If you cannot find an item on this list, care- fully check around/inside the machine and packaging materials. Often, these items get lost in packaging materials while unpack- ing or they are pre-installed at the factory.

SUFFOCATION HAZARD!

Keep children and pets away from plastic bags or packing materials shipped with this machine. Discard immediately.

-19-