Grizzly G0740 owner manual Stop

2.Clear away all tools and objects used during assembly, lubrication, and preparation.

3.make sure that the chuck and jaws, if installed, are secure (refer to Chuck and Faceplate Mounting on Page 32).

Note: If a chuck is not installed on the lathe, you do not need to install one for this test.

4.push the STOP button on the control panel (see Figure 25), and point the coolant nozzle into the chip pan.

Note: In the next step, use the chuck key to rock the chuck back-and-forth so that the gears will mesh as you make the adjust- ments. Be sure to remove the chuck key before continuing.

6.set the spindle speed to 50 RPM as follows:

a.move the spindle range lever so that the arrow on top of its hub is pointing toward the right-hand spindle speed chart (see Figure 27).

Cutting Fluid

Pump Switch

Power

Lamp

Jog

Button

STOP

Button

Speed
Speed Lever	Spindle Range
	Lever
	Spindle Speed
	Lever Set To
	“A” (50 RPM)
A	Spindle Range

Figure 25. Control panel.

5.Disengage the quick-change gearbox from the drive train by moving the feed range lever to the neutral (middle) position (see Figure 26).

Feed

Range Lever

Low Feed Range Lever

Neutral

High

Figure 26. Feed range lever.

Model G0740 (Mfg. Since 11/12)

B	D	Lever Pointing
		To The Right-
	C	Hand Speed
		Chart

Figure 27. Spindle speed set to 50 RPM.

b.Move the spindle speed lever so that the "A" on its hub is directly under the arrow on the headstock. This corresponds to the "A" in the right-hand spindle speed chart.

c. turn the two-speed motor switch to the LOW position. This enables all the low speeds in the green columns of the spindle speed charts.

-27-