Grizzly G0740 owner manual Recommended Adjustments, Factory adjustments that should be verified

4.Use the foot brake to stop spindle rotation, then run the lathe at 215 RPM for 10 minutes with the gearbox range lever on the head- stock in the L (low) position, and then run the lathe another 10 minutes with the lever in the H (high) position.

5.While the oil is still warm and any metal par- ticles are still suspended in the oil, change the headstock and gearbox oil (refer to Lubrication beginning on Page 65 for detailed instructions).

6.Check the V-belt tension, and if necessary, re-tension them (refer to V-Beltson Page 79 for detailed instructions).

Congratulations! The spindle break-in is com- plete.

-30-

Recommended

Adjustments

The following adjustments have been made at the factory. However, because of the many variables involved with shipping, we recommend that you at least verify the following adjustments to ensure the best possible results from the lathe.

Step-by-step instructions for these adjustments can be found on the pages referenced below.

Factory adjustments that should be verified:

•tailstock alignment (see Page 40).

•Compound and cross slide backlash adjust- ment (see Page 76).

•gib adjustments (see Page 77).

Model G0740 (Mfg. Since 11/12)