4:1
Camera body 503CW | Reassembly |
The lubricants mentioned in the text are:
Grease = Isoflex Topas L32
Oil = Isoflex PDP 48
Gear housing (30324)
Lubricate carefully the washer (810840) with oil. Lubricate with grease and fit (incl. the above mentioned washer) the ratchet wheel (20924) into the front section of the gear housing (30304).
Lubricate with grease and fit the gear wheel (13169).
Note. The correct relationship between the two gears before inserting the locking pin (812106) into the shaft.
Fit the locking ring (810938) and the activating hook (20919), lubricate carefully with oil. Fit the spring (816504) and the washer (810826).
Place the stop gear (13509) into the rear section of the gear housing (13157).
Lubricate the shaft of the ratchet wheel (20924) and put the front and rear section together.
821033 |
13157 |
22355 |
13509 |
810826 |
816504 |
812106 |
810938 |
13169 |
20919 |
810840 |
30304 |
20924 |
Fig. 11
Fit the mirror cam (22355) and secure with the screw (821033).
Note! The position of the mirror cam (22355) relative to ratchet wheel (20924).
Fig.11.
Mechanism plate (21125-1)
Ensure the auxiliary shutter release connecting rod coupling and the control gear wheel move freely (i.e. with no friction). Lubricate lightly with oil. Lubricate the gear wheel’s cam with grease.
If it is necessary to replace the coil spring (30384) fit it |
|
into the spring mounting on gear wheel (22699) as |
|
shown in fig.12. Use a new spring, contained in its |
|
plastic ring. Lubricate with grease. | Fig. 12 |
Revision 1 | May 2000 |
