4:2
Camera body 503CW | Reassembly |
Mount the gear housing (30324) to the mechanism plate.
On the reverse side of the mechanism plate lubricate the hub with grease and fit the shutter stop bar (20912) spring (816802), washer (810404) and clip (817112). Fig. 13.
Note! The gear housing must be rotated when fitting the stop bar (20912).
Lubricate the cam of the gear wheel (13182) with grease and fit to the mechanism plate.
Note! The position of the gear wheel engagement according to fig.14.
Hold the gear wheels in position and on the reverse side of the mechanism plate, position washer (810932) and lubricate the hub with grease. Fit gear wheel (22699) together with the coil spring. Lubricate the coil spring with grease.
Assemble the lid (14280) and temporarily secure with the screw (822605). Fig. 15.
Tension the spring by rotating the gear wheel (22699) in the direction shown in fig. 14. Test the operation by pushing the shutter release connecting rod up and down several times (tension the spring after each operation). The gear wheels should rotate freely. Fig. 14.
20912 | 816802 |
| 810404 |
| 817112 |
30324
Fig. 13
13182 22699
Gear alignment
Fig. 14
14280
822605 | Gear housing |
Fig. 15
Lubricate with grease and fit the intermediate gear wheel (13167), bearing bracket (13171), nut (13116) and two screws (820016).
Position the bearing bracket (13171) and mesh the gear teeth, secure the two mounting screws (820016).
Fig. 16.
| 820016 |
| 13116 |
| 13171 |
Mounting | 13167 |
position |
Fig. 16
Revision 2 | May 2000 |
