Hasselblad 10026 service manual Front bayonet plate

6:2

Camera body 503CW Front bayonet plate

The hole for the locating pin (812202) is bored with

1.15mm drill. Use tool V-2211 for driving in the pin. Drive the pin in until the face of the tool touches the front bayonet plate. When a new front plate is installed the hole must be drilled using tool 902658 (V-2075), which is equipped with two drill bushes.

Fit the governor (30386) using two screws (820014), ensure the gears mesh and then secure the screws.

Remove the swarf and lubricate the bevel gears with grease. Force grease using a syringe into the three small holes and lubricate the weight of the centrifugal brake.

Note! Do not over lubricate.

V-2211

1.40 mm

Fig. 57

Revision 0 October 1996