4:5
Camera body 503CW | Reassembly |
Rear plate (30300)
Fitting the rear plate
Fig. 23 and 24. |
|
Lubricate the shutter driving arm’s shaft hub and the |
|
mirror’s moving peg with grease. Connect the arm and |
|
the connecting rods and fix the rear plate into the |
|
chassis. Ensure that the mirror actuating lever grips the |
|
pin on the mirror frame and that the mirror is |
|
positioned correctly on the upper side of the mirror |
|
support. |
|
Connect the driving arm (22781) to the mirror frame |
|
and secure with a clip (817115). Do not forget the |
|
washer (810649) between the frame and the arm. |
|
Check that the mirror and shutter driving arms move | Fig. 23 |
freely. |
|
Secure the rear plate to the camera using six screws (820015) and two screws (821017).
Check that the mirror and the auxiliary shutters are centred and move freely. Adjust if necessary the brackets (Qty. 4) in the side hinges of the auxiliary shutter and mirror frame.
If the magazine hook (22423) has been removed, put it back with two screws (823640) and seal the screws with loctite.
Seal between the rear plate and both side walls using black silicone or similar. (Lower and upper end).
820015 | 820017 |
Fig. 24
Revision 0 | October 1996 |
