1.3.1Example of operation in basic display mode ("b037" = "04" [factory setting])
-Only basic parameters can be displayed in basic display mode. (All parameters in monitor mode, four parameters in function mode, or 20 parameters in extended function mode)
-Other parameters are not displayed. To display all parameters, select the full display mode ("b037" = "00").
<Displayable parameters and sequence of display>
No. | Display code | Item | |
1 | d001 to d104 | Monitor display | |
2 | F001 | Output frequency setting | |
3 | F002 | Acceleration (1) time setting | |
4 | F003 | Deceleration (1) time setting | |
5 | F004 | Operation direction setting | |
6 | A001 | Frequency source setting | |
7 | A002 | Run command source setting | |
8 | A003 | Base frequency setting | |
9 | A004 | Maximum frequency setting | |
10 | A005 | [AT] selection | |
11 | A020 | Multispeed frequency setting | |
12 | A021 | Multispeed 1 setting | |
13 | A022 | Multispeed 2 setting | |
14 | A023 | Multispeed 3 setting | |
15 | A044 | 1st control method | |
16 | A045 | V/f gain setting | |
17 | A085 | Operation mode selection | |
18 | b001 | Selection of restart mode | |
19 | b002 | Allowable | |
20 | b008 | ||
21 | b011 | Retry wait time after trip | |
22 | b037 | Function code display restriction | |
23 | b083 | Carrier frequency setting | |
24 | b084 | Initialization mode selection | |
25 | b130 | Selection of overvoltage suppression | |
function | |||
|
| ||
26 | b131 | Setting of overvoltage suppression level | |
27 | C021 | Setting of intelligent output terminal 11 | |
28 | C022 | Setting of intelligent output terminal 12 | |
29 | C036 | Alarm relay active state |
Note:
If a desired parameter is not displayed, check the setting of function "b037" (function code display restriction). To display all parameters, specify "00" for "b037".
1 - 21
