Honda Power Equipment TPG-7000H-DXE, TPG-2900H-DX, TPG-6000H-DX C.Replacement Of Engine Muffler

Tsurumi’s Operation, Service, and Repair Manual

79

76

	78
	77
82	74

73

80

75 85

84

81

83

Figure 22: Battery Enclosure Exploded View

(6)Perform repair and/or maintenance, then proceed as follows.

(a)Align screw holes in battery base plate (74) with holes in support tubes (73). Install and tighten four bolt-and-washer assemblies (82) and four nuts (83).

(b)Align screw holes in battery shield plate (75) with holes in support tubes (73). Install and tighten four bolt-and-washer assemblies (84) and four nuts (85).

C.REPLACEMENT OF ENGINE MUFFLER

(Models TPG-4300H-DX, TPG-6000H-DX, and TPG-7000H-DXE)

(1)Refer to Figure 23. Disconnect muffler from engine exhaust connection.

(2)Remove screw (H-26) securing the muffler to support bracket (18).

(3)Remove inner shield (H-23) and separate muffler from bracket (18).

(4)Remove spacer (H-37) from the muffler support bracket (18).

(5)Install shield (H-23) and replacement muffler (H-20).

(6)Install spacer (H-37) between the lugs of the support bracket (18). Use a probe (such as a Phillips screwdriver) to align spacer (H-37) with the mounting lugs in the lower muffler support bracket (H-19) with the muffler support bracket (18).

(7)Install bolt (H-35) and washer (H-36) in lower lug of bracket (18). Insert screw far enough to engage the outermost screw threads in the lower support bracket (18); do not tighten screw at this time.

(8)Install new exhaust flange gasket (H-21) and connect exhaust flange to the muffler.

(9)Tighten all fasteners and apply torque to the values shown in Table 10.

Removal/Installation Page 42