Honda Power Equipment TPG-6000H-DX, TPG-2900H-DX Tsurumi’s Operation, Service, and Repair Manual

Models: TPG-4300H-DX TPG-6000H-DX TPG-7000H-DXE TPG-2900H-DX

1 92
Download 92 pages 43.16 Kb
Page 86
Image 86
INSTALLATION OF BATTERY ENCLOSURE

Tsurumi’s Operation, Service, and Repair Manual

INSTALLATION OF BATTERY ENCLOSURE

1.Position assembled enclosure on crossover support on bottom of generator frame. Install two bolts (11) through support tubes (1) and generator frame. Install and tighten nuts (12).

2.Align holes in support tubes (1) with holes in upper frame. Install two bolts (13) and nuts (14).

3.Check to make sure all bolts and nuts are tight.

CLIP, SPRING

 

WASHER, AND

 

WING NUT

 

HOLD-DOWN

 

PLATE (4)

TIE-

BASE

DOWN

PLATE (2)

ROD

INSTALLATION OF BATTERY

1.Set battery on base plate (2). Place hold-down plate (4) on front edge of battery.

2.Install hooked end of tie-down rods (5) in holes in base plate (2). Put threaded ends of tie-down rods (5) up through holes in hold-down plate (4).

3.Install raised edge clips (6) toward terminals. Install wing nuts (7) on tie down rods. Tighten wing nuts (7).

4.Connect battery cables to terminals.

5.Start the generator to verify that the battery is properly connected.

Page A-3

Appendix A

Page 86
Image 86
Honda Power Equipment TPG-6000H-DX Tsurumi’s Operation, Service, and Repair Manual, Installation Of Battery Enclosure