Honda Power Equipment TPG-2900H-DX manual Install Axle Assembly and Wheels, Install Handles, Fig

Tsurumi’s Operation, Service, and Repair Manual

Step 1 - Install Axle Assembly and Wheels

1)Follow this step carefully in order to do the installation task safely. With the unit elevated, place the block which will hold the load of the unit between the ground and the lower chassis side where it meets the handle. This will ensure that the necessary installation space is available.

2)Place the axle assembly (A) underneath the frame (B) (See Fig. 3) and attach the axle assembly to the bottom of the frame with two U-bolts, nuts and washers.

3)Use two short U-bolts, two nuts and two washers to se- cure each axle assembly to the bottom of the frame.

4)There are 8 holes in each axle assembly for use with the U-bolts. Use 4 holes to secure each axle assembly to the pipe frame.

5)Important: Ensure the bolts/washers are balanced as far apart to form a square.

6)Attach the axle assembly at an optional position in or- der to prevent contact with other parts.

7)The axle assembly is adjustable with a sliding system. The adjustable pipe frame width is 330mm - 530mm.

8)Tighten bolts with the proper torque 78 - 95 lbf-m (8.8 -10.8 N-m).

9)Next, install each tire with the 4 bolts & nuts facing each other to the inside. Therefore, the hubcap should face the outside.

10)Insert the cotter pins into the axle hole and bend the end of each cotter pins with pliers to secure the tires in place.

Fig. 3

Bolt & Nut

Inside

(B)

(A)

Outside

Step 2 - Install Handles

1)Carefully stabilize the generator or pump unit and install handles near the engine side (C) by placing each handle on the bottom pipe frame. Then attach the handle to the pipe frame with the two U-bolts (D) and the two handle brackets. (See Fig. 4)

2)Use the two long U-bolts, two nuts and two washers to secure each handle bracket to the frame. Tighten bolts with the proper torque 78 - 95 lbf-m (8.8 -10.8 N-m).

Fig. 4

(D)

(C)

Page C-3 Appendix C