Honda Power Equipment TPG-6000H-DX manual Tsurumi’s Operation, Service, and Repair Manual, Page

Tsurumi’s Operation, Service, and Repair Manual

(7)Refer to Figure 32. Wrap electrical tape around the threads of a bolt to form a seal; do not put tape on the first two threads of the bolt.

(a)For Models TPG-4300H-DX,TPG-6000H-DX, and TPG-7000H-DXE, use a 12mm, 1.5-pitch bolt with a 25mm thread length.

(b)For Model TPG-2900H-DX, use a 10mm, 1.5 pitch bolt with a 25 mm thread length.

Wind tape on bolt

Figure 32: Wrapping Bolt with Tape

NOTE:

•Have shop towels available to wipe up spilled oil.

(8)Install the bolt in the center of the rotor shaft refer (to Figure 33). Turn the bolt into the shaft; the force required to turn the bolt will increase as the pressure increases.

Page 55 Removal/Installation