Honda Power Equipment TPG-2900H-DX, TPG-7000H-DXE manual J.Replacement Of Front Panel Components

Tsurumi’s Operation, Service, and Repair Manual

J.REPLACEMENT OF FRONT PANEL COMPONENTS

(1)Removal/Installation of Front Panel and Control Box

NOTE:

•To ease the replacement of components, drain and remove the fuel tank and remove the front panel and/or control box (32) from the frame.

(a)Refer to Figure 35. Remove four screw and washer assemblies (34) to separate con- trol box (32) from front panel (29).

(b)Disconnect flexible tube (12) from rear cover (7).

(c)Tag and disconnect generator wires. Pull generator wires free from the control box (32).

CAUTION:

•Carefully remove the front panel from the frame to avoid damage to wiring and/or electrical or electronic components.

•Use care to avoid damage by the wire loop that passes through the coil on the idle control unit.

(d)Remove four frame bolts (31) at the corners of the front panel (29). Separate the front panel (29) from the frame.

(e)Replace panel-mounted or control box-mounted components as applicable.

(f)After replacing the panel-mounted component, connect generator and engine wires using the tags as a guide. Install control box (32) on front panel (29) and secure with screw and washer assemblies (34).

(g)Install front panel (29) on frame and secure with four frame bolts (31).

(2)Reset Pushbutton (TPG-7000H-DXE Only)

(a)Refer to Figure 35. Remove front panel (29) and control box (32) (refer to

Removal/Installation of Front Panel and Control Box).

(b)Disconnect wiring.

(c)Remove screws (H-31) and pushbutton (H-30).

(d)Install replacement pushbutton (H-30) and secure with screws (H-31).

(e)Connect wiring.

(f)Install front panel (29) and control box (32) (refer to Removal/Installation of Front Panel and Control Box).

Page 57 Removal/Installation