Honda Power Equipment TPG-6000H-DX manual Replacement of Generator Stator, Replacement of Stator

Tsurumi’s Operation, Service, and Repair Manual

G. REPLACEMENT OF GENERATOR STATOR

NOTE:

•Refer to exploded view in Replacement Parts section for parts information. The item numbers in the following procedure are identical to those in the Replacement Parts exploded views.

(1)Drain and remove fuel tank (H-5) (refer to Replacement of Fuel Tank for removal instruc- tions).

(2)Remove the muffler (H-20) and shields to gain access to generator (refer to Replacement of Muffler for removal instructions).

(3)Remove muffler support bracket (18), (Figure 23) as follows:

(a)For Model TPG-2900H-DX.Remove bolt and washer assembly (19), (Figure 24). Remove flanged nut (26) securing bracket (18) to rear cover (7).

(b)For Model TPG-4300H-DX,TPG-6000H-DX, and TPG-7000H-DXE.Remove two bolt and washer assemblies (19), (Figure 23) securing bracket (18) to rear cover (7).

(4)Remove the flexible tube (12), (Figure 28) from the rear cover (7). Pull the wires out of the access opening in the rear cover. Tag and disconnect the wires.

1

13	2
	6
H-1		14
	5
		12
	3
	4
		7
		8
	11	9
	10

Figure 28: Replacement of Stator

(5)Remove bolts (8) and washers (9). Use a plastic, rubber, or other soft-faced hammer to loosen the rear cover (7). Alternately tap upward on the generator mounting lugs until the rear cover can be removed by hand.

(6)With the rear cover loosened, carefully position the rear cover so you have access to ground screw and washer assembly (14).

Page 51 Removal/Installation