Honda Power Equipment TPG-7000H-DXE, TPG-2900H-DX Tsurumi’s Operation, Service, and Repair Manual

Tsurumi’s Operation, Service, and Repair Manual

NOTE:

•The rotor (2), (Figure 28) at this point is free to rotate and must be kept from rotating to enable removal of the through bolt (4).

(2)Restrain the rotor to keep it from rotating.

(3)Put a box-end wrench on the hex of the through bolt (4).

(4)Using a plastic, rubber, or other soft-faced hammer, strike the side of the wrench using sharp blows to loosen the through bolt (4).

(5)When the through bolt (4) is loosened, it can easily be removed.

Through

Bolt

Figure 30: Removal of Through Bolt

NOTE:

•In the steps that follow, motor oil is used to generate hydraulic pressure. Hydraulic pressure is used to separate the tight-fitting engine and generator shafts.

(6)Refer to Figure 31. With the generator in the vertical position, pour a small amount of motor oil in the bore in the center of the rotor shaft. (The oil level should be flush with the end of the rotor shaft.)

Oil Container

Rotor

Figure 31: Pouring Oil in Rotor Shaft

Removal/Installation Page 54