Example #3: What is the device’s current setting for Codabar Coding Enable?
Enter: cbrena?.
Response: CBRENA1[ACK]
This response indicates that the device’s Codabar Coding Enable (CBRENA) is set to 1, or on.
Example #4: What are the device’s settings for all Codabar selections?
Enter: cbr?.
Response: CBRENA1[ACK],
SSX0[ACK],
CK20[ACK],
CCT1[ACK],
MIN2[ACK],
MAX60[ACK],
DFT[ACK].
This response indicates that the device’s Codabar Coding Enable (CBRENA) is set to 1, or on; the Start/Stop Character (SSX) is set to 0, or Don’t Transmit;
the Check Character (CK2) is set to 0, or Not Required; concatenation (CCT) is set to 1, or Enabled;
the Minimum Message Length (MIN) is set to 2 characters; the Maximum Message Length (MAX) is set to 60 characters; and the Default setting (DFT) has no value.
Trigger Commands
You can activate and deactivate the document reader with serial trigger commands. First, the document reader must be put in Manual/Serial Trigger Mode either by scanning the Manual/Serial Trigger Mode barcode (page
Activate: | SYN T CR |
Deactivate: SYN U CR
The document reader scans until a barcode has been read, until the deactivate command is sent, or until the serial
Resetting the Standard Product Defaults
If you aren’t sure what programming options are in your document reader, or you’ve changed some options and want the factory settings restored, scan the Standard Product Default Settings barcode below.
Standard Product Default Settings
The chart on the following pages lists the factory default settings for each of the menu commands (indi- cated by an asterisk (*) on the programming pages).
10 - 3
