Honeywell 4800dr Beeper Duration Good Read, LED Good Read, LED Indicator State, Number of Beeps Good Read

3 - 2
Beeper Duration – Good Read
The beeper duration codes modify the length of the beep the document reader emits on a good read.
Default = Normal.
LED – Good Read
The LED indicator can be programmed On or Off in response to a good read. Default = On.
LED – Indicator State
The LED indicator can be programmed to have an idle state of either Off or On, with a good read blink in
the opposite state. When programmed to LED Indicator Off, the LED indicator is Off in its idle state. It
blinks On for a good read, then returns to its idle Off state. When programmed to LED Indicator On, the
LED indicator is On in its idle state. It blinks Off for a good read, then returns to its idle On state. (LED
Indicator On can also be used as a power on indicator.)
Default = LED Indicator Off.
Number of Beeps – Good Read
The number of beeps of a good read can be programmed from 1 - 9. The same number of beeps will be
applied to the beeper and LED in response to a good read. For example, if you program this option to
have five beeps, there will be five beeps and five LED flashes in response to a good read. The beeps
and LED flashes are in sync with one another. To change the number of beeps, scan the barcode below
and then scan a digit (1-9) barcode and the Save barcode on the Programming Chart inside the back
cover of this manual.
Default = One.
* Normal Beep
Short Beep
* On
Off
* LED Indicator Off
LED Indicator On
Number of Pulses