Honeywell 4800dr Codabar Concatenation, Codabar Message Length

6 - 3
When Check Character is set to Validate, but Don’t Transmit, the unit will only read Codabar barcodes
printed
with a check character, but will not transmit the check character with the scanned data.
Codabar Concatenation
Codabar supports symbol concatenation. When you enable concatenation, the document reader looks
for a Codabar symbol having a “D” start character, adjacent to a symbol having a “D” stop character. In
this case the two messages are concatenated into one with the “D” characters omitted.
Default = On.
Select Require to prevent the document reader from decoding a single “D” Codabar symbol without its
companion. This selection has no effect on Codabar symbols without Stop/Start D characters.
Codabar Message Length
Scan the barcodes below to change the message length. Refer to Message Length Description (page 6-
2) for additional information. Minimum and Maximum lengths = 2-60. Minimum Default = 4, Maximum
Default = 60.
* No Check Character
Validate Modulo 16
and Transmit
Validate Modulo 16, but
Don’t Transmit
A12D D34A
Codabar
Character Stop Start StopStart
On
* Off
Require
Minimum Message Length
Maximum Message Length