Honeywell 7900 manual Port Menu, Configuring the Client, Configuration Screens

Port Menu

On the main screen, tapping on a port opens a popup menu that allows the port to be enabled or disabled, configured, or deleted.

The port menu enables you to use 802.1X authentication, change the port configuration, or remove it from the port list. If there are no entries in the Port list, follow the advice in the troubleshooting section to resolve the problem.

Port Menu Options
Enable and Disable	These commands enable or disable 802.1X authentication on the port. The port should be enabled
	before the protocol is started. Enabling a port is not the same as starting it (see Client Menu on page
	9-17); however, both actions are required for the Client to work.
Configure	Opens the port configuration screen; see Accessing the Client Configuration Area on page 9-21.
Delete	Removes an adapter from the port list. An unused port may be deleted from the port list. The radio
	card must not be in the device or the radio must be turned off.
	Ports appear in the list only when the 802.1X protocol binds to the adapter. The protocol binds to the
	adapter when the adapter is in the device and the Client software is installed, or Install Protocol is
	selected from the Client menu (see Client Menu on page 9-17).

Configuring the Client

The Client is configured in two separate areas:

1.Client Configuration area - enables you to configure user settings and is accessed from the Client menu.

2.Port Settings area - enables you to configure Network Properties settings for individual wireless networks and is accessed from the Port menu.

Configuration Screens

Both Client Configuration and Port Settings areas lead you through a series of setup screens. The following diagram displays the different screens and how they are related:

9 - 20 Dolphin® 7900 Series Mobile Computer User’s Guide