Honeywell 7900 manual Communications, Setting Up the HomeBase for USB Communication

1.Insert the end of the battery without the locking tab into the bottom of the auxiliary well opening.

2.Snap the battery into place with a hinging motion. The Aux Battery LED lights orange.

3.Use the AUX Battery LED to monitor charging progress.

Communications

There are two types of communication: USB and RS-232.

USB	The HomeBase also supports USB communications via the USB port located on the back. The
	HomeBase acts as a USB device by interfacing the USB signals of the Dolphin to the USB of the host
	computer. Using a standard USB cable, the HomeBase’s USB interface allows the Dolphin terminal
	to communicate with a personal computer or to be networked through a USB hub.
RS-232	The HomeBase supports RS-232 communications via the RS-232 Communications Port located on
	the back of the device. This port enables the Dolphin terminal to communicate to a personal
	computer, modem, or any RS-232 device using a standard serial cable and communications
	software.

Note: The HomeBase should have only one type of interface cable connected at a time, either USB or RS-232. You must be using ActiveSync, version 3.7 or higher.

Required Equipment

•HomeBase powered by a power cable and power adapter cable from Hand Held Products

•USB Cable

•Serial Cable

•ActiveSync v3.7 or higher

•Windows® 98 Second Edition*, Windows® Me, Windows® 2000, or Windows® XP computer.

Note: The HomeBase does not support Windows NT® when using a USB connection. This is because Windows NT does not support USB. *Windows® 98 second edition provides full USB support.

Setting Up the HomeBase for USB Communication

The Dolphin terminal is defaulted to support USB communications out of the box.

To Install the HomeBase Using USB

1.Plug in the power supply and connect it to the back of the HomeBase.

2.Plug the USB cable into the back of the HomeBase.

3.At this point, the hardware is installed and operating. You may need to reboot your PC to complete the installation process.

Setting up the Terminal for ActiveSync Communications

1.On the terminal, tap Start > ActiveSync > Tools > Options. Activesync opens displaying the PC tab.

2.In the Use this PC drop-down list, select the name of the host PC.

13 - 6 Dolphin® 7900 Series Mobile Computer User’s Guide