DCP200 Profile Controller & Recorder -Product Manual
Page 60 Configuration & Use 51-52-25-150, Issue 1 –April 2009
Segment Details (Cont….)
Segment Loop Enter the segment to loop back to, and the number of times to loop
back, before continuing forward to the next segment, if the segment
type is Loop. Note: Two Loops cannot be set to cross each other.
Segment Auto-
Hold Type
From: None (no auto-hold); Above Setpoint (hold if too high only);
Below Setpoint (hold if too low only) or Band (hold if too high or low).
Segment Auto-
Hold Band Value
The distance from setpoint beyond which the profile is held for the
selected Auto-Hold Type. The profile continues once the process
returns within this band.
Segment Hold
Release Type
Sets the method used to release the profile from hold if the segment
type is Hold. From: Digital Input A; Digital Input B; Front Keys or
Time Of Day. (Time of day on Recorder version only )
Hold Release Time
The time of day (hh:mm:ss) when a Hold Segment will release if the
Release Type is Time Of Day. Release occurs at the next
occurrence of this time.
Times To Repeat
Sequence
The number of times the entire sequence of profiles should run. – if
the last segment is Repeat Sequence Then End.
Segment End Type The action taken after the profile ends normally. From: Control
outputs off; Maintain last profile setpoint; Use controller setpoint.
Select Profile To
Join
Choose a profile to join to from the list provided – if the last
segment type is Join. The selected profile will start immediately the
current profile ends.
Segment Events Select the event(s) to be active during this segment. For end
segments, events selected to be active stay on until the unit exits
from profiler mode or a new profile runs.
Edit A Profile Header Choose the profile to be edited from the list of names provided, then
alter any values as required –The profile header details are as
shown in “Create A Profile” above.
Edit A Profile Segment Choose the profile, then the segment to be edited from the lists
provided. Alter any values as required –The profile segment details
are as shown in “Create A Profile” above. Note: The last segment
type can only be set to Join, End or Repeat Sequence Then End.
Insert A Segment
Choose the profile, then the new segment’s position from the lists
provided –Enter the new segments values as required –The profile
segment details are as shown in “Create A Profile” above. Note: The
new segments type cannot be set to Join, End or Repeat Sequence
Then End.
Delete A Segment Choose the profile, then the segment to be deleted from the lists
provided. End, Join or Repeat segments cannot be deleted.
Delete A Profile Choose the profile to be deleted from the list of names is provided.
The user is then prompted confirm that it should be deleted.
Delete All Profiles Deletes all profiles from memory. The user is prompted to confirm
that all profiles should be deleted. Caution: Use with care!