DCP200 Profile Controller & Recorder -Product Manual
Page 58 Configuration & Use 51-52-25-150, Issue 1 –April 2009
Table 19. Automatic Tuning Menus Screens
Automatic Tuning
Menu:
Automatic Tuning Mode
Unlocking
Enter correct code number to access the Automatic Tuning Menu.
Pre-Tune wTurns Pre-Tune on/off. Pre-Tune is disabled in On-Off Control Mode;
if the PV is less than 5% of span from SP; during Profiles or if the
Setpoint is Ramping.
Pre-Tune Status Shows the current Pre-Tune status. Active or Inactive.
Self-Tune Turns Self-Tune on/off. Self-Tune is disabled in On-Off Control
Mode.
Self-Tune Status Shows current Self-Tune status. Active or Inactive.
Auto Pre-Tune Enable Enables/Disables Automatic Pre-Tune. When enabled, this attempts
to perform a Pre-Tune at every power-up. Normal Pre-Tune
engagement rules are applied (see Pre-Tune above).
Profiler Setup Menu
Refer to the Profiler Option section of this manual for more details about the profiler features.
Screens marked will not time-out automatically. They must be completed for a valid profile
to be created.
Table 20. Profiler Setup Menu Screens
Profiler Menu:
General
General Profile Configuration: Settings that apply to all profiles
Profile Run/Hold
Signal
Selects the method used to Run or Hold a profile. From: Digital Input
A; Digital Input B or Key Pad Only (using the either the Profile
Control Menu or an Operation Mode screen).
Profile Abort
Signal
Selects the method used to force a profile to end prematurely. From:
Digital Input A; Digital Input B or Key Pad Only (using either the
Profile Control Menu or an Operation Mode screen).
Control In
Operation Mode
Enables/disables the ability to control profiles (run, hold or abort)
from Operation Mode.
Enable Edit While
Running
Enables/disables the ability to edit profiles whist a profile is running
(even if selected, the current or next segment of the running profile
will not change until after the profile is restarted).
Create A Profile Creates a new profile. A header is created first, followed by the
segments –see below. A warning is displayed if the maximum
number of 64 profiles or 255 segments is exceeded.