Honeywell MAXPRO-NET manual Make a NEW Macro

4.3 MAKE A NEW MACRO, CONTINUED

The system will now begin recording operator keyboard actions. These may be recorded in a REALTIME mode whereupon running of the macro the operator actions will be played back with the same timing with which they were recorded, or in AUTO-TIMING mode whereupon operator actions will be played back automatically timed. The

recording mode may be toggled during recording by pressing the key. The

prompt:

or

will then be displayed briefly to indicate the current mode.

NOTE: To redefine a macro that has been used previously, it must first be deleted. Refer to the following section DELETE A MACRO.

To end the recording, press the key again. The message prompt:

will be displayed briefly.

Your macro is now defined with the recorded keystrokes. Now, test the MACRO to see if it executes correctly.

The newly defined macro will be saved back onto disk automatically by the system after 30 seconds of inactivity or by initiating a ’Save Now’ function from System Macros.

Rev. A	4-4	HMXMU001056
		03/16/05