3.3HALTING A SCAN SEQUENCE

To halt a scan sequence, the operator must have selected the monitor running that scan sequence.

When the key is pressed, the message:

will be displayed. The last camera selection made by the scan sequence will remain displayed on the monitor.

To restart a previously halted scan sequence, press the key followed by the key. A number is not required.

for example, .. restarts the last scan sequence halted for this monitor.

If the monitor is already running a scan sequence before manually selecting a camera (or a different scan sequence), then the following message appears:

Rev. A

3-3

HMXMU001056

 

 

03/16/05

Page 27
Image 27
Honeywell MAXPRO-NET manual Halting a Scan Sequence