3.4PAUSING A SCAN SEQUENCE
Sometimes, it is necessary to temporarily pause the scan sequence. This allows you to manually step forwards and backwards through the scan sequence.
To pause a scan sequence, you must already be selecting a monitor that is running the desired scan sequence.
Press the 
key. This message will be displayed:
The current camera selection made by the scan sequence will remain displayed on the monitor. The scan sequence number and the current entry position in the scan sequence will also be displayed on the monitor.
While in the 'SCAN PAUSED' mode, you can manually step forwards and backwards through the scan sequence list, using the following keys:
Steps the scan sequence forward to the NEXT selection in the list. This camera is then displayed on the monitor.
Steps the scan sequence backwards to the PREVIOUS selection in the list. The camera is then displayed on the monitor. When the sequence
reaches Entry 1, if it is stepped back once more (by pressing the 
key again), to pseudo Entry 0, the Dwell Period will be displayed (in seconds).
CAUTION: Entry 0 is not a valid camera selection; it contains the Dwell Period for that particular scan sequence.
To release the scan sequence, press the 
key. The scan sequence is now running again.
Rev. A | HMXMU001056 | |
|
| 03/16/05 |
