Honeywell MAXPRO-NET manual Errors, Licxxdaysleft, Licexpired

	Menu is busy	The system MENU is already being used by another operator.
		Wait a while and try again.
	Test mode frozen	The diagnostic test mode display has been frozen. The system
		MENU cannot be used until the diagnostic test mode is released.
		Wait for the service engineer to complete their testing, then try to
		access the system MENU again.
	LIC:XX_DAYS_LEFT	This prompt indicates that you are running a trial version of the
		software.
		This text is prompted in the message line, if the remaining trial
		period is greater than 5 days. If the trial period is less than or equal
		to 5 days, then the message is shown in the mode line and the
		message is displayed on every monitor once after every thirty
		selections.
	LIC:EXPIRED	This message is displayed on all monitors when the trial period of
		software expires. This is displayed on the mode line of every
		monitor. No switching is allowed once the license expires and
		every issue of the switching command results in a display of this
		message.
8.9	ERRORS
	Message Prompt	Explanation
	?? Fault errorlog	The ERRORLOG.MAX report file on the storage disk is full. You
		should contact technical support as soon as possible to have the
		report file analyzed. Once the reported problems have been dealt
		with, the service engineer should delete the report file and re-boot
		the system.
	Runtime error #..	The system has ceased operation completely. Record the Runtime
		error number and call technical support for immediate support.
		Try re-booting the MAXPRO-Net Server to re-establish normal
		system operation.
	?? Macro error #..	The internal macro environment in your system has reported an
		incomplete macro event. The macro error number can be used to
		identify the event problem. Keep written log records of the macro
		error number together with the system event causing the macro
		error and the time/date it occurred. Macro errors can occur in a
		fully functioning system but should be attended to during normal
		system maintenance.
	Subrack Fail (xxx)	The equipment subrack (xxx) in the hardware has failed to respond
		to polling commands. The data communication channel to the
		subrack may be disconnected or the subrack controller module
		may have failed. Call technical support for immediate support.
	HL Fail (xxx)	The external computer system (xxx) connected to the system has
		failed to respond to polling commands. The data communication
		channel to this equipment may have failed. Call technical support
		for immediate support.

Rev. A	8-9	HMXMU001056
		03/16/05