Link unsuccessful | Beep will sound |
|
|
Bluetooth Remote Device LED |
|
|
|
LED on Bluetooth Device | Behavior |
|
|
Yellow LED blinks at 2 Hz | Linking in progress |
|
|
Off | Disconnected or unlinked |
|
|
Yellow LED blinks at 50 Hz | Bluetooth transmission in progress |
|
|
Yellow LED blinks at the same rate as the paging beep (1 Hz) | Paging |
|
|
Green LED blinks once a second | Disabled indication |
|
|
Upon startup, if the remote Bluetooth scanner sounds a long tone, this means the scanner has not passed its automatic Selftest and has entered isolation mode. If the scanner is reset, the sequence is repeated. Contact Technical Assistance (page
Bluetooth Printer Setup
The Bluetooth managed device should be as close as possible (no more than 32.80 feet [10 meters] line of sight in a quiet environment) to the MX9 during the pairing process.
1.Open the Bluetooth control panel.
2.Tap Discover. Locate the remote Bluetooth printer in the Discovery panel.
3.Tap and hold the stylus (or
4.Select Pair as Printer to pair the MX9 with the Bluetooth managed printer.
The devices are paired. The Bluetooth managed printer may respond with a series of beeps or LED flashes.
Refer to the remote Bluetooth printer manufacturer’s User Guide; it may be available on the manufacturer’s web site. Contact Technical Assistance (page
Note: If there is no beep or no LED flash from the remote Bluetooth printer, the MX9 and the printer are currently paired.
7 - 14