1.Detach the bottom hook of the hand strap (if installed).
2.Tilt the end (with the terminals) of the fully charged battery pack into the upper end of the battery compartment, and firmly press the other end until it is fully inserted into the battery compartment.
3.Push down on the battery until the retaining clip clicks into place.
4.Replace the hand strap clip in its holder (if installed).
The MX9 draws power from the battery immediately upon successful connection.
Check battery status in the Battery control panel.
Remove Battery
To remove the battery, complete the following steps:
1.Place the MX9 in Suspend mode.
2.Detach the bottom hook of the hand strap (if installed).
3.Slide the battery retaining clip down to release the main battery.
4.Pull the battery up and out of the battery well with a hinge motion.
5.Place the discharged battery pack in a powered MX9 battery charger.
Insert Battery in HazLoc MX9
1.Detach the bottom hook of the hand strap (if installed).
2.Tilt the end (with the terminals) of the fully charged battery pack into the upper end of the battery compartment, and firmly press the other end until it is seated into the battery compartment.
3.Push down on the battery pack until it clicks into place.
4.Place the tethered plastic locking tab over the battery latch, matching up the screw holes in the MX9 body and the screw holes in the tethered plastic locking tab.
5.Using a flat head screwdriver, secure the battery in the battery well by securing the locking screws to the MX9 body.
6.Replace the hand strap clip in its holder.
Remove Battery from HazLoc MX9
1.Place the MX9 in Suspend mode.
2.Detach the bottom hook of the hand strap (if installed).
3.Using a flat head screwdriver, unfasten the tethered plastic lock's captive locking screws.
4.Place the tethered plastic locking tab to one side. Do not remove or unfasten the tether.
5.Slide the battery locking tab down to release the battery pack.
6.Pull the battery up and out of the battery well with a hinge motion.
7.Place the discharged battery pack in a powered MX9 battery charger.
Charging/Recharging the Main Battery
Warning. Only use Honeywell batteries as replacements: MX9380BATTERY
Note: The MX9 Battery Charger is designed for an indoor, protected environment. It is not authorized for use in areas designated as Hazardous Locations.
New batteries must be fully charged prior to use.
The main battery can be recharged in an AC powered Battery Charger after the battery has been removed from the MX9 or its packing material when new.
The main battery while in the MX9 can be recharged using several different methods.
Note: An external power source is required before the main battery in the MX9 will recharge.
2 - 8