DC/DC Power Supply Installation, Screws on Side of Lid
For use with
•9000311PWRSPLY – Power Supply,
•9000313PWRSPLY – Power Supply,
Shown With Lid Attached | Shown With Lid Removed | ||||
• Lid is secured with screws on the side of lid. | • | Input and output connector blocks under lid. | |||
| • | One positive (Vin+), negative | |||
|
| ( |
|
| ) connection in input block. |
|
|
|
| ||
|
|
|
| ||
• One positive (Vo+) and negative
If your DC/DC power supply does not look like the image above, see DC/DC Power Supply Installation, Screws on Top of Lid (page
Connecting Electrical Cables to Power Sources
The DC/DC power supply is used to provide vehicle power to the MX9 when it is placed in a DC powered vehicle cradle.
Specifications for Electrical Supply
Input Voltage | Always observe input voltage range specified for the DC/DC power supply. |
|
|
Output Voltage | 13.5 VDC ± 10% |
|
|
Fuse | 5 A (slow blow fuse). Fuses are USER SUPPLIED |
|
|
Note: Refer to the Wiring Schematic that follows for wiring colors and connections.
Caution: | For proper and safe installation, the input power cable must be connected to a fused circuit on the |
! | vehicle. This fused circuit requires a five Amp maximum time delay (slow blow) high interrupting |
rating fuse. If the supply connection is made directly to the battery, the fuse should be installed in the | |
| positive lead within 5 inches of the battery positive (+) terminal. Note: For North America, a UL |
| Listed fuse is to be used. |
|
|
Caution: | Usage in areas where moisture can affect the power supply connections should be avoided. The |
! | power supply should be mounted in a dry location within the vehicle or placed in a suitable protective |
enclosure. | |
|
|
Caution: | For installation by trained service personnel only. |
! |
|
|
|
14 - 15