A fully depleted spare battery recharges in approximately four hours in the MX9 powered cradle. Charging time may take longer if a tethered scanner, connected to the Serial port and drawing power from the cradle, is used.

The spare battery charger can recover a battery that has had its safety circuit tripped.

The spare battery well is molded in the shape of the MX9 main battery. The spare battery can be inserted in the battery well in only one direction. When there is an MX9, with or without a handle, docked in the cradle, a spare battery can still be inserted in the charging bay. You do not need to undock the MX9 before inserting or removing a Spare battery.

Stabilize the cradle with one hand when inserting/removing the spare battery, if necessary.

Inserting a Spare Battery

1.Hold the battery with the charging terminals facing down, toward the charging pocket.

2.Tilt the end (with the charging terminals) into the re-charging terminals at the front end of the spare battery charging bay. Slide the battery forward until it is fully inserted into the battery bay.

3.Push down on the spare battery until the catch clicks into place, securing the spare battery in the battery bay. This will ensure the charging contacts on the spare battery connect with the re-charging contacts in the battery bay.

4.The Spare charging bay LED illuminates indicating the battery is properly seated in the charging bay.

Removing a Spare Battery

A green Spare battery LED signifies the spare battery is charged.

Remove the Spare battery by sliding the latch in and pulling the Spare battery up, with a hinging motion, and out of the charging bay. The Spare charging bay LED turns Off.

Desktop Cradle Help

The following is intended as an aid in determining whether the MX9 battery pack or the cradle battery charger may be mal- functioning.

Issue

Cause

Solution

 

 

 

Battery pack does not

Different manufacturer's battery pack,

Check if the battery pack is part number 161888-

fit in battery well.

or there is an object in the battery

0001 or a low temperature battery 161915-0001. If

 

well.

not, do not use.

 

 

Remove the object from the battery well.

 

 

 

No battery pack in

Dirt or foreign objects are in the

Unplug cradle from outlet. Remove any dirt or

spare battery charging

battery well.

foreign objects from battery well.

well, but the charging

 

If the LED continues to stay ON, the cradle may be

LED is on.

 

defective. Return charger to an authorized

 

 

Honeywell service center.

 

 

 

14 - 9