Remove the protective film from its container. Remove any protective backing from the film sheet by lifting the backing from a corner of the film. Discard the backing.

Apply the film to the touch screen starting at one side and smoothing it across the display. If air bubbles appear, raise the film slightly and continue smoothing the film across the display until it covers the glass surface of the display. If dust, lint or smudges are trapped between the protective film and the glass display, remove the protective film, clean the display and apply the protective film again.

Adjusting the Keypad Backlight

The keypad backlight is white can be set to On or Off. The default value is On. When set to Off, the keypad backlight does not turn on during Suspend/Restart or reboots. When set to On, the keypad backlight follows the display backlight setting. The keypad backlight turns off when the display backlight dims.

Setting Date and Time Zone

Note: The first time the MX9 is powered on, or the device returns from a clean boot, the operating system may reset the Time to the factory default value.

To set the Time Zone, tap the Date / Time on the Today screen or tap Start > Settings > Clock and Alarms icon. Select the physical time zone. If required, adjust the time and calendar date and tap OK.

Grab Time Utility

The GrabTime utility can be configured to synchronize the time with a local server during each reboot function.

Autolaunch Time-Sync

Start > Settings > Control Panel > MX9 Options > Communication

By default, TimeSync does not automatically run on the MX9. To enable TimeSync to run automatically on the MX9 using the GrabTime utility, check this checkbox.

Synchronize with a Local Time Server

By default, GrabTime synchronizes via an Internet connection. To synchronize with a local time server:

1.Use ActiveSync to copy GrabTime.ini from the My Device > Windows folder on the MX9 to the host PC.

2.Edit the copy of GrabTime.ini on the host PC. Add the local time server’s domain name to the beginning of the list of servers. You can optionally delete the remainder of the list.

3.Copy the modified GrabTime.ini file to the My Device > System folder on the MX9. The System/GrabTime.ini file takes precedence over the Windows/GrabTime.ini file. System/Grabtime.ini also persists after a coldboot; Windows/ Grabtime.ini does not persist.

Setting the Power Timers

Tap Start > Settings > Power > Advanced. Adjust the timer values for battery power and external power and tap OK. When the timer expires, the MX9 enters Suspend mode.

2 - 11