Attaching the Trigger Handle
Pressing the trigger on the trigger handle activates the integrated scanner and functions the same as the Scan key on the keypad. With the handle installed the Scan key on the keypad remains active. The trigger duplicates the operation.
•The handle is built of a durable, flexible plastic.
•The handle will not detach from the MX9 if the unit is dropped.
•The trigger handle is a mechanical device. Battery or external A/C power is not required for operation.
•The trigger handle does not need to be removed when replacing the main battery pack.
•The trigger handle might also be called a pistol grip.
Equipment needed: Torque wrench capable of torquing to 3±1 in/lb (.34±.11 N/m).
Either the trigger handle or the hand strap is attached, not both. Honeywell recommends that, in the absence of a trigger handle, the hand strap be used at all times.
1.Place the MX9 with the screen facing down, on a flat stable surface.
2.Remove the hand strap and hand strap base, if installed.
3.Place the trigger base into the molded area on the back of the MX9.
4.Ensure that the battery can be inserted into the battery compartment before securing the trigger handle in place.
5.Attach the trigger handle to the MX9 (as shown above) with the screws provided.
6.Torque the pan head screws to 3±1 in/lb (.34±.11 N/m).
7.Secure the strap tether to the trigger handle.
8.Place the stylus in the stylus holder in the trigger handle.
Periodically check the trigger handle for wear and the connection for tightness. If the handle gets worn or damaged, it must be replaced. If the trigger handle connection loosens, it must be tightened or replaced before the MX9 is placed in service.
2 - 19