18)Check for water leaks.
19)Replace the panels in their correct positions.
20)Turn on the power supply.
J. Adjustment of Water Regulating Valve (water-cooled model)
The water regulating valve (also called "water regulator") is factory set, and generally no adjustment is required. However, when necessary, adjust the water regulator using the following procedures.
1)Prepare a thermometer to check the condenser drain temperature. Attach a pressure gauge to the
2)Five minutes after a freeze cycle starts, confirm that the thermometer reads 104°F to 115°F (40°C to 46°C). If it does not, rotate the adjustment screw by using a flat blade screwdriver until the temperature is in the proper range. See Fig. 4. Next, check that the reference pressure is in the range indicated in the Head Pressure table in the Performance Data section. If it is not in the proper range, verify the refrigerant charge.
Top View
Fig. 4
3)Check that the condenser drain temperature is stable.
K.Removal and Replacement of Headmaster (Condensing Pressure
Regulator - C.P.R.) (remote
CAUTION
1.Always install a new drier every time the sealed refrigeration system is opened.
2.Do not replace the drier until after all other repair or replacement has been made. Install the new drier with the arrow on the drier in the direction of the refrigerant flow.
3.When brazing, protect the headmaster and drier by using wet cloths to prevent the headmaster and drier from overheating. Do not allow the headmaster or drier to exceed 250°F (121°C).
1)Turn off the power supply.
2)Remove the panels from the remote condenser unit.
3)Recover the refrigerant and store it in an approved container.
4)Before heating, break off the stub on the dome to release the dome charge.
5)Disconnect the headmaster.
6)Place the new headmaster in position.
7)Remove the drier, then place the new drier in position.
78
