Table 7.2 | General HP Jetdirect Messages (8 of 10) | |
|
|
|
Message |
| Description |
|
| |
PSERVER CLOSED | The print server requested a termination of the connection | |
CONNECTION | with the HP Jetdirect print server. No error exists or is | |
|
| indicated. Make sure the print server is running, and |
|
| restart it if necessary. |
|
|
|
READY |
| The HP Jetdirect print server has successfully connected |
|
| to the server and is awaiting data. |
|
| |
RECEIVE BUFFER | Run the | |
ERROR |
| then on again. If the error persists, replace the |
|
| HP Jetdirect print server. |
|
| |
RETRY ERROR | Check the Ethernet cable. Make sure your HP Jetdirect | |
|
| print server is correctly attached to your network. |
|
|
|
SQE ERROR |
| Run the |
|
| then on again. If the error persists, replace the |
|
| HP Jetdirect print server. |
|
| |
TFTP IN PROGRESS | The HP Jetdirect print server is currently in the process of | |
|
| obtaining its basic IP configuration information through |
|
| TFTP and has not detected any errors. |
|
| |
TFTP LOCAL ERROR | The TFTP transfer of the configuration file from the host | |
|
| to the HP Jetdirect print server failed with the local print |
|
| server encountering some form of inactivity timeout, or |
|
| excessive retransmissions situation. |
|
| |
TFTP REMOTE ERROR | The TFTP transfer of the configuration file from the host | |
|
| to the HP Jetdirect print server failed with the remote host |
|
| sending a TFTP ERROR packet to the print server. |
|
| |
TFTP RETRIES | The overall retrying of the TFTP transfer of the | |
EXCEEDED |
| configuration file from the host to the HP Jetdirect print |
|
| server has exceeded a retry limit. |
|
| |
TRANSMIT ERROR | Check the network topology and verify all cable segments. | |
|
| |
TRYING TO CONNECT | The HP Jetdirect print server is trying to connect to the | |
TO SERVER |
| print server or NetWare file server after being configured. |
|
| Wait for the print server to establish a connection with the |
|
| print or file server. |
|
| |
TURN PRINTER OFF/ON | This message may appear after you upgrade to a new | |
|
| version of firmware. When this message appears, turn the |
|
| print server off, then back on to enable any new |
|
| functionality that was recently downloaded. |
|
|
|
76 HP Jetdirect Configuration Page Messages
ENWW
