Table 3.2 describes parameters that may be included in the TFTP configuration file.
Table 3.2 TFTP Configuration File Parameters (1 of 3)
Enables or disables the embedded web server on the HP | |
| Jetdirect print server. To enable, set to 1. To disable, set |
| to 0. |
|
|
The number of seconds that an idle print data connection | |
| is allowed to remain open. Since the card supports only |
| a single TCP connection, the idle timeout balances the |
| opportunity of a host to recover or complete a print job |
| against the ability of other hosts to access the printer. |
| The acceptable values range from 0 to 3600 (1 hour). If |
| “0” is typed, the timeout mechanism is disabled. The |
| default is 90 seconds. |
|
|
allow: netnum | Provides an entry into the host access list stored on the |
[mask] | HP Jetdirect print server. Each entry specifies a host or |
| network of hosts that are allowed to connect to the |
| printer. The format is “allow: netnum [mask]” where |
| netnum is a network number or host IP address, and |
| mask is an address mask of bits applied to the network |
| number and host address to verify access. Up to 10 |
| access list entries are allowed. If there are no entries, all |
| hosts are permitted access. For example: |
| allow: 192.0.0.0 255.0.0.0 allows hosts on network |
| 192. |
| allow: 192.168.10.1 allows a single host. In this case, the |
| default mask 255.255.255.255 is assumed and is not |
| required. |
|
|
Specifies the maximum segment size (MSS) that the HP | |
| Jetdirect print server will advertise for use when |
| communicating with local subnets (MSS=1460 bytes or |
| more) or remote subnets (MSS=536 bytes): |
| 0 (default) All networks are assumed to be local |
| (MSS=1460 bytes or more). |
| 1 Use MSS=1460 bytes (or more) for subnets, and |
| MSS=536 bytes for remote networks. |
| 2 All networks are assumed to be remote (MSS=536 |
| bytes), except the local subnet. |
|
|
location: | Identifies the physical location of the printer (SNMP |
| sysLocation object). Only printable ASCII characters are |
| allowed. The maximum length is 64 characters. The |
| default location is undefined. (Example: 1st floor, |
| south wall) |
|
|
24 TCP/IP Configuration
ENWW