Table 7.2 | General HP Jetdirect Messages (2 of 10) | |
|
|
|
Message |
| Description |
|
| |
CONFIGURATION | The configuration information for the NetWare functions is | |
ERROR |
| not stored correctly on the HP Jetdirect print server. Rerun |
|
| the installation software to reconfigure. If this error |
|
| persists, there may be a problem with the HP Jetdirect |
|
| print server. |
|
|
|
CRC ERROR |
| Check the network topology and verify all cable segments. |
|
| Check for damaged cables. |
|
|
|
DHCP NACK |
| After several attempts, the DHCP server has failed to |
|
| acknowledge the configuration. The Jetdirect print server |
|
| will restart the configuration process. |
|
| |
DISCONNECTED | The Novell NetWare protocol is disconnected. Check the | |
|
| server and the print server. |
|
| |
DISCONNECTING | The server has been shut down because of a configuration | |
FROM SERVER | change or reset request. This message automatically | |
|
| clears after a few seconds, unless the printer is offline, is |
|
| in an error state, or is servicing another I/O port or another |
|
| network protocol. |
|
| |
DISCONNECTING - SPX | The SPX connection to the print server was lost after the | |
TIMEOUT |
| connection had been made. This indicates a possible |
|
| network problem, or a problem with the print server. Make |
|
| sure all cables and routers are functioning correctly. Try |
|
| restarting the print server. |
|
| |
DUP NODE ADDRESS | The HP Jetdirect print server found another station on the | |
|
| ring that already has the address which the HP Jetdirect |
|
| print server wishes to use. Make sure that all addresses |
|
| are unique. |
|
| |
ERR NEGOTIATING | A failure was detected when selecting the buffer size to be | |
BUFFER SIZE | used when reading print data from the file server. This may | |
|
| indicate a network problem. |
|
| When the HP Jetdirect print server is configured for |
|
| multiple file servers, the error is only displayed on the |
|
| configuration page if none of the file servers was |
|
| successfully connected. |
|
| |
FAIL RESERVING | The SPX connection to the print server was lost when the | |
PRINTER NUM | HP Jetdirect print server attempted to reserve the printer | |
|
| number. This indicates a possible network problem, or a |
|
| problem with the print server. Make sure all cables and |
|
| routers are functioning correctly. Try restarting the print |
|
| server. |
|
| |
FRAMING ERROR | Check the network topology and verify all cable segments. | |
|
| Check for damaged cables. |
|
|
|
70 HP Jetdirect Configuration Page Messages
ENWW
