Appendix D
To connect the printer using the Push Button Method
1.On the printer control panel, touch 
(right arrow), touch Setup, and then touch Network.
2.Touch
3.When prompted, touch Push Button.
4.On the wireless router or wireless access point, press and hold the WPS button for 3 seconds. Wait for about 2 minutes. If the printer connects successfully, the wireless light stops blinking but remains lit.
To connect the printer using the PIN Method
1.On the printer control panel, touch 
(right arrow), touch Setup, and then touch Network.
2.Touch
3.When prompted, touch PIN. The WPS PIN appears on the display.
4.Open the configuration utility or software for the wireless router or wireless access point, and then enter the WPS PIN.
NOTE: For more information about using the configuration utility, see the documentation provided with the router or wireless access point.
Wait for about two minutes. If the printer connects successfully, the wireless light stops blinking but remains lit.
Set up the printer using the embedded web server (EWS)
If the printer is connected to a network, you can use the printer’s embedded web server (EWS) to set up wireless communication.
1.Open the EWS. For more information, see To open the embedded web server.
2.On the Home tab, click Wireless Setup Wizard in the Setup box.
3.Follow the onscreen instructions.
TIP: You can also set up wireless communication by entering or changing individual wireless settings. To change these settings, on the Network tab, click Advanced in the Wireless (802.11) section on the left, change the wireless settings, and then click Apply.
Change the connection type
After you have installed the HP software and connected the printer to your computer or to a network, you can use the HP software to change the connection type (for example, from a USB connection to a wireless connection).
NOTE: If you are changing to a wireless connection, make sure that an Ethernet cable has not been connected to the printer. Connecting an Ethernet cable turns off the printer's wireless capabilities. Also, you might be prompted to temporarily connect a USB cable during the setup process.
To change from an Ethernet connection to a wireless connection
1.On the printer control panel, touch 
(right arrow), touch Setup, and then touch Network.
2.Touch Wireless Setup Wizard, and then touch OK.
3.Follow the display instructions to complete the setup.
NOTE: If you cannot find the wireless network name (SSID) and wireless password (WPA passphrase, WEP key), see Before you begin.
To change from a USB connection to a wireless connection
198 Network setup
