◆
◆
Menu Reference
Front Panel Menu Reference "System/Inputs" Menu
Limits Off On
Press this softkey to toggle between the test limits being on or off. The default is “Off”.
Max
Press this softkey to enter the upper measurement limit in the range
90.00dBm. Use the , , and hardkeys to change the value. To confirm your choice press the appropriate measurement units. Max must be greater than
Min .
◆Min
Press this softkey to enter the lower measurement limit in the range
•Power Ref Off On
Press this softkey to switch the POWER REF output on or off. This output is used as the signal source for calibration. This softkey is commonly used for troubleshooting. The default is “Off”.
Note | During calibration the power meter automatically switches the | ||
| power reference oscillator on (if it is not already on), then after | ||
| calibration it switches it to the state it was in prior to the | ||
| calibration. | ||
|
|
|
|
| • |
|
|
| Error List |
|
Press this softkey to display any power meter errors and access a menu which allows you to clear and scroll through any power meter errors. The errors are viewed in a first in first out (FIFO) basis.
■ Clear Errors
Press this softkey to clear all the errors which are stored in the power meter’s memory.
■ Next
Press this softkey to move to the next error in the error queue.
The displayed error message is individually cleared each time
Next is selected.
HP |