Power Meter Operation
Setting Measurement Limits
Setting Measurement Limits
The power meter can be configured to verify the power being measured against an upper and/or lower limit value. The range of values that can be set for upper and lower limits is
To set the limits:
1. Press System , A Input Settings , More , Limits . The current
Inputs
setting of the maximum and minimum limits are displayed under the Max and Min softkeys respectively.
2.To change either of these settings press the appropriate softkey. The power meter displays the current value in a pop up window. Modify this value (see below) until the desired value is displayed.
■Use or to modify the digit on which the cursor is currently positioned.
■Use or to move to other digits.
3.To confirm your choice press the appropriate measurement units.
Limits can be disabled and
A typical application for this feature is shown in Figure
Figure
Power Meter
Swept Source |
| Device |
|
| Under Test |
OUT | IN | OUT |
CHANNEL A
INPUT
HP |