RMOTE Error Messages
The following error messages are returned to the current log device when an error is encountered by the program RMOTE.
RMOTE Error Messages
Message | Meaning | Action |
|
|
|
AUTO “BYE” FAILED | The BYE generated | This error is for the operator's |
| automatically when the EX | information only; the session at |
| command is entered with a | the HP 3000 is closed |
| HELLO outstanding has failed. | automatically. |
| May occur if the link has been |
|
| disconnected since the HELLO |
|
| was entered. |
|
|
|
|
BAD LU | A negative LU number was | Correct the LU and try again. |
| specified in a MO command. |
|
|
|
|
DS/1000 ERROR nnn | The reported numeric | Check NSARPA error code for |
| NSARPA/1000 error occurred | action. |
| during a file move operation. |
|
|
|
|
DS/3000 ERROR nnn | The reported numeric DS/3000 | See appropriate numeric error |
| error occurred during a file move | for explanation. |
| operation. |
|
|
|
|
HELLO FAILED OR LINE | The HELLO command was not | Check syntax and try again or |
DOWN | correct or could not be | check to see if the HP 3000 line |
| transmitted due to a line error. | is down. |
|
|
|
ILLEGAL STATUS | RTE returned an SC03 | See SC03 for an explanation. |
| scheduling error for an RU, ON, |
|
| or RW command. |
|
|
|
|
INVALID INPUT | Wrong or missing parameter or | Check parameters or transfer |
| wrong prompt on transfer file | file. |
| input. |
|
|
|
|
INVALID REMOTE LU | From SW command: Either the | Check LU and try again. |
| LU is not in the 3000 LU table |
|
| built when NSINIT was |
|
| executed, or it is not the LU of |
|
| the currently active session |
|
| opened on the 3000. |
|
|
|
|
LINK IS DISCONNECTED | The link to the HP 3000 is not | Check link and try again. |
| functioning (physically |
|
| disconnected or an electrically |
|
| •open" circuit). |
|
|
|
|
MPE FILE ERROR nnn | The reported FS/3000 error | See the appropriate FS/3000 |
| occurred during a file move | error code for an explanation of |
| operation. | this error. |
|
|
|
NEED “HELLO” | Attempt to send a command to | Issue a HELLO. |
| the HP 3000 before issuing |
|
| HELLO. |
|
|
|
|
Program Specific Error Messages 459