HP NSARPA/1000 manual 26

Code	Meaning	Action
-14	Directory full.	This error code is reported by
		the file system at the reporting
		node. Refer to the appropriate
		operating system manual to
		determine the meaning.
-15	Illegal file name.	This error is reported by the file
		system at the reporting node.
		Refer to the appropriate
		operating system manual to
		determine the meaning.
-16	Illegal type or size = 0.	This error code is reported by
		the file system at the reporting
		node. Refer to the appropriate
		operating system manual to
		determine the meaning.
-17	Illegal read/write on type 0 file.	This error is reported by the file
		system at the reporting node.
		Refer to the appropriate
		operating system manual to
		determine the meaning.
-26	Bad entry number in RFAM.	Check your program code to
	Indicates that the file was never	make sure that the file access
	opened correctly, or the	calls are used correctly.
	pseudoDCB in the user
	program has been destroyed, or
	the specified pseudoDCB is
	incorrect due to a programming
	error, or the DCB for this file
	access call was released when
	the same file was opened to
	another DCB within the
	program.
-28	No internal table space in RFAM.	Close some files before opening
	An attempt was made to open	any more files.
	more files than the version of
	RFAM used at the destination
	node can handle.
-29	Internal RFAM tables invalid.	Contact your HP representative.
-33	On DCRET, the specified file size	The remote file create
	is negative.	subroutine does not allow a
		negative file size because a
		communication line error may
		occur which would leave all
		available disk space on the
		referenced disk allocated to the
		created file.
-100	•Break" was entered during an	No action is necessary.
	FCOPY file transfer.
-999	NonNSARPA error. May be an	Check parameters. If all
	IO or RN error.	parameters are correct, consult
		your Network Manager. Do not
		call DSERR; it will return invalid
		information.

28 Numeric Error Codes