HP UX 11i v1 Networking Software manual Following settings, If you have Then

Preparing to Install or Upgrade the NetWare Client Software

Preparing Client Workstations

If you have	Then
EISA or MCA	Run the workstation’s setup or reference program.
network boards	This program lists the values for your network board
	settings.
ISA network	Look at the network board itself to obtain the specific
boards	settings. The documentation provided with your
	network board will direct you where to find each
	setting value.
PCI Local Bus	Run the workstation’s setup or reference program.
network boards	This program lists the values for your network board
	settings.

NOTE:	If you have a network connection already, type “NVER” in the PUBLIC directory at
	the command line to view board settings.
	It is important that you keep a record of the settings you use to configure the
	network boards, because the NetWare Client installation program requires
	specific information about the network board installed in each client
	workstation.
	Before loading the client installation program, record the values for the
	following settings:
	• Hardware interrupt
	In most cases, you can use IRQ3 or IRQ5 for your network board if these are not
	already used by COM2 and LPT2. If neither IRQ3 nor IRQ5 is available, see the
	manufacturer’s documentation.
	The following table shows the IRQ settings that are commonly used by other
	devices, and the settings that might be available.

4-6