HP UX 11i v1 Networking Software manual 11-9

NOTE:

NOTE:

Configuring Client Workstations for Desktop SNMP Services

Modifying DOS System and NetWare Client Configuration Files

By default, Desktop SNMP services are not enabled when you install the NetWare Client software. To enable Desktop SNMP services, complete the following procedure.

Procedure

1Modify the C:\NWCLIENT\STARTNET.BAT file to load the Desktop SNMP transport files.

Add the following commands in the STARTNET.BAT file after the line that loads the VLM.EXE file:

•If you are using IPX transport, add

stpipx

•If you are using UDP/IP transport, add

stpudp

You can add both commands if you use both IPX and UDP/IP transport.

2Modify the C:\NWCLIENT\STARTNET.BAT file to load the MIB file.

Add the following command in the STARTNET.BAT file after the line that loads the VLM.EXE file:

hrmib.exe

3Ensure that the HRMIB.INI file exists in the same directory as the HRMIB.EXE file does.

If you are running LAN Workplace, make sure you do not load the SNMP.EXE file provided with the LAN Workplace package.

The installation program for LAN Workplace creates a file called LANWP.BAT that loads the LAN Workplace software. Check this file for a line reading SNMP. It would be listed directly following the line TCPIP.

If the SNMP line is present, delete it or comment it out.

4Add the following DOS SET command in the STARTNET.BAT file to set the correct time zone for your area:

set tz = time_zone

Refer to your DOS manual for the exact syntax for your particular time zone.

11-9