Installing or Upgrading NetWare Client Software
What Happens during Installation
NOTE:The user interface for the NETWARE.DRV file is the NWUSER.EXE file.
[boot.description]
•The line network.drv= is replaced by network.drv=NetWare (vx.x).
•If you are installing for Windows for Workgroups (WFWG), the following modification is made:
The line secondnet.drv= is replaced by secondnet.drv=Novell NetWare (workstation shell 4.0 and above).
This notifies MS Windows Setup of the NetWare device version you are using.
[Network]
•If you are installing for Windows for Workgroups (WFWG), the following modification is made:
The line winnet= is replaced by winnet=novell/00040000.
This specifies the type of network and version used with WFWG.
•The line multinet= is appended to appear as multinet=NetWare4.
This identifies other network operating systems running on the network.
[386Enh]
•The line network=dosnet is replaced by network=*vnetbios;vipx.386;vnetware.386.
This specifies the type of network used with MS Windows 386 enhanced mode.
•The line TimerCriticalSection= is replaced by TimerCriticalSection=1000.
NetWare uses this setting to ensure that network traffic on your client runs smoothly.
•The line OverlappedIO= is replaced by OverlappedIO=OFF.
This specifies that virtual machines cannot issue a request to read or write to a disk until any previous read and write requests have been completed.
•The line PSPIncrement= is replaced by PSPIncrement=5.
This specifies the amount of additional memory, in
Windows should reserve in each successive virtual machine.