User Manual

 

Aolynk DR811/DR814 ADSL2+Broadband Router

4 Web-based Management

Figure 4-28 ZIPB setting

This page allows you to:

Enable/disable the ZIPB mode.

Perform advanced ZIPB configurations.

If the ZIPB is currently disabled, you may click the button to enable it. If the

ZIPB is currently enabled, you may click the button to disable it.

To select which of your LAN computers will use the public IP address, click on the drop-down list below Choose which computer will use the public IP address, position the cursor over the entry and left-click to select a LAN computer, and then click

the button.

To perform advanced ZIPB configurations, proceed according to the following steps:

Select the LAN interface that ZIPB will run on: click on the LAN interface drop down list and select an interface.

Select the WAN interface that ZIPB will run on: click on the WAN interface drop down list and select an interface.

Once you have configured ZIPB, click the button.

&Note:

Make ensure that ZIPB is disabled before you configure ZIPB. Edit the configurations and click OK, the new configuration will take effect after you enable ZIPB. Configuration changes on ZIPB will not be kept permanently, so you need to configure it again whenever the Router is restarted. In this way, remember to renew the IP address of the ZIPB host first.

37

Page 40
Image 40
Huawei Aolynk DR811, Aolynk DR814 user manual Zipb setting