Trolling Motor Transducer Installation | Humminbird HDR 650 specs

7.If you unplugged the transducer cable at the beginning of this procedure, plug it back into the depth sounder.

NOTE: The connector is keyed to prevent reverse installation, so be careful not to force the plug into the connector the wrong way.

NOTE: Neither water, spilled gasoline, nor oil will affect the performance of the transducer.

Trolling Motor Transducer Installation

Several styles of the transducer are compatible with trolling motor mounting. If you have a trolling motor bracket, refer to the separate installation instructions that are included with the bracket.

Trolling Motor Transducer Options

If you don’t have a trolling motor transducer, there are several options:

•You may purchase a TrollingMotor Adapter kit that will allow you to mount the transducer on the trolling motor.

•You may also exchange your NEW and UNASSEMBLED transducer (with mounting hardware included) for a trolling motor transducer.

NOTE: There are also several transducer switches available that support the configuration of two depth sounders with one transducer or two transducers with one depth sounder.

NOTE: Call the Humminbird® Customer Resource Center at 1-800-633-1468for details and pricing, or visit humminbird.com for more information.

29Trolling Motor Transducer Installation

Image 33

Humminbird HDR 650 manual Trolling Motor Transducer Installation, Trolling Motor Transducer Options

Contents

HDR 650 Installation Operations Manual Thank You Table of Contents Maintenance How Sonar Works Installation Overview Installing the HDR Cutting the Mounting Hole Locating the HDR 650 Mounting Position HDR Face Plate Trim Ring Tabs Customizing and Assembling the HDR Installing the HDR Collar Gasket DashboardViewHDR 650 Control Head Installing the Buzzer Connecting to the Power SupplyBuzzer Inline Fuse Holder Installing the Transducer Transducer Installation Overview Locating the Transducer Mounting Position Transom Transducer InstallationRivets Strakes TransomHull StepRib Deadrise Angle Level Preparing the Mounting Location Assembling the Transducer and Initial Mounting 4th hole Mark InitialDrill Holes Bead Alignment Number Transom Angle Measured Distance Transom Angle in degrees MeasuredWeight Distance Knuckle Beads Ratchet RibBead Ratchet Snap the pivot arm down into place Trailingedge One click too low Leading edge One click too high Routing the Cable Transom Mount Transducer Installation Test and Finish the Installation Connecting the CableStoring Excess Cable Gathered at one location as shown See the illustration Storing Excess Cable Level Seam aligned with boat hull Rib Ratchet Bead Transom Mount Transducer Installation Locking Down the Transducer Optional Inside the Hull Transducer Installation Positioning the Transducer and Preferred Mounting Area Trial Installation Routing the Cable Make sure the position of the transducer is marked Permanently Mounting the Transducer Trolling Motor Transducer Options Trolling Motor Transducer Installation Operating the HDR Units Shallow Alarm Icon IndicatesHDR 650 Control Head Depth Key Functions Overview Power On/Off Set Units Units Set Shallow Alarm Icon Shallow Alarm Set Deep Alarm Icon Deep Alarm PostiveOffset NumberIcon NegativeOffset NumberIcon Maintenance HDR 650 MaintenanceTransducer Maintenance HDR 650 Doesnt Power Up Troubleshooting No Continuous Depth Display in Very Shallow Water No Bottom Reading on the DisplayScreen Fades, Images are not Sharp Bottom Reading Disappears During a Hard Turn Year Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Specifications Contact Humminbird