Installation Overview | Humminbird HDR 650 instruction

Installation Overview

Before you start installation, we encourage you to read these instructions carefully in order to get the full benefitfrom your HDR 650 DigitalDepth Sounder.

In addition to the hardware included in the installation kit, you will also need the following supplies:

•powered hand drill and various drill bits, includinga 2 1/8" hole saw if your boat does not have an existing gauge hole

•Phillips-head and flat-head screwdrivers

•ruler or measuring tape

•pen or pencil

•12 Volt power source (your boat's battery)

•marine-grade silicone sealant (for sealing drilled holes)

•two-part, slow-cure epoxy (for inside-the-hull transducerinstallation only)

NOTE: If you are wiring directly to the boat's battery, you will also need a 1 Amp fuse and a fuse holder.

Installation

2

Image 6

Humminbird HDR 650 manual Installation Overview

Contents

HDR 650 Installation Operations Manual Thank You Table of Contents Maintenance How Sonar Works Installation Overview Installing the HDR Locating the HDR 650 Mounting Position Cutting the Mounting Hole Customizing and Assembling the HDR HDR Face Plate Trim Ring Tabs Installing the HDR Collar Gasket DashboardViewHDR 650 Control Head Installing the Buzzer Connecting to the Power SupplyBuzzer Installing the Transducer Inline Fuse Holder Transducer Installation Overview Rivets Strakes TransomHull Transom Transducer InstallationLocating the Transducer Mounting Position StepRib Level Deadrise Angle Preparing the Mounting Location Assembling the Transducer and Initial Mounting 4th hole Mark InitialDrill Holes Transom Angle in degrees MeasuredWeight Distance Bead Alignment Number Transom Angle Measured Distance Knuckle Beads Ratchet RibBead Ratchet Snap the pivot arm down into place One click too high Trailingedge One click too low Leading edge Routing the Cable Transom Mount Transducer Installation Storing Excess Cable Gathered at one location as shown Connecting the CableTest and Finish the Installation See the illustration Storing Excess Cable Level Seam aligned with boat hull Bead Rib Ratchet Transom Mount Transducer Installation Locking Down the Transducer Optional Inside the Hull Transducer Installation Trial Installation Positioning the Transducer and Preferred Mounting Area Routing the Cable Permanently Mounting the Transducer Make sure the position of the transducer is marked Trolling Motor Transducer Installation Trolling Motor Transducer Options HDR 650 Control Head Units Shallow Alarm Icon IndicatesOperating the HDR Depth Power On/Off Key Functions Overview Units Set Units Shallow Alarm Set Shallow Alarm Icon Deep Alarm Set Deep Alarm Icon NegativeOffset NumberIcon PostiveOffset NumberIcon Maintenance HDR 650 MaintenanceTransducer Maintenance Troubleshooting HDR 650 Doesnt Power Up Screen Fades, Images are not Sharp No Bottom Reading on the DisplayNo Continuous Depth Display in Very Shallow Water Bottom Reading Disappears During a Hard Turn Year Limited Warranty Humminbird Service Policy Returning Your Unit for Service Specifications Specifications Contact Humminbird