IBM DS4700 manual Installing a Telco bezel, Replacing an E-DDM

Note: Use Table 55 on page 194 to verify the proper replacement locations of your E-DDMs.

1.Lift up on the handle and gently push the E-DDM CRU into the empty bay until the hinge of the tray handle latches beneath the storage subsystem bezel, as shown in Figure 30.

exp80018

Figure 30. Replacing an E-DDM

2.Push the tray handle down until the latch clicks into place.

3.Repeat step 1 and step 2 to replace additional E-DDMs.

Installing a Telco bezel

Complete the following step to install a bezel on a DS4700 Express Storage Subsystem if the storage subsystem is shipped with one:

vGrasp the sides of the bezel and snap it onto the DS4700 Express chassis, as shown in Figure 31 on page 54. The bezel is self-aligned in the recessed opening in the front of the DS4700 Express chassis.

Chapter 2. Installing the storage subsystem 53