Note: Perform this step if the attached storage expansion enclosures are EXP710s or EXP100s only. The EXP810 storage expansion enclosure IDs are automatically set by the controllers to be unique when they are cabled together.
12.Perform one of the following cabling tasks to enable management of the DS4700 Express configuration:
vIf you are using
vIf you are using
13.Connect the power cables for the DS4700 Express. See “Cabling the ac power supply for ac models” on page 111.
14.Power on the attached storage expansion enclosure and the DS4700 Express Storage Subsystem using the procedure described in “Powering on the storage subsystem” on page 119.
15.Install the DS4000 Storage Manager host software on the management workstation (for
16.Use the DS4000 Storage Manager host software to verify the configuration.
17.Review and perform the procedures described in “Performing the DS4000 Health Check process” on page 117.
Handling static-sensitive devices
Attention: Static electricity can damage electronic devices and your system. To avoid damage, keep
To reduce the possibility of electrostatic discharge (ESD), observe the following precautions:
vLimit your movement. Movement can cause static electricity to build up around you.
vHandle the device carefully, holding it by its edges or its frame.
vDo not touch solder joints, pins, or exposed printed circuitry.
vDo not leave the device where others can handle and possibly damage the device.
vWhile the device is still in its
vRemove the device from its package and install it directly into your system unit without setting it down. If it is necessary to set the device down, place it in its
vTake additional care when handling devices during cold weather because heating reduces indoor humidity and increases static electricity.
Chapter 2. Installing the storage subsystem 33
